REQUEST A QUOTE
CLOSE

Stoncor PRO-STRUCT

DESCRIPTION

PREPARATION:

All defective areas and areas which have degraded due to carbonation and chloride ingress or areas of insufficient concrete cover will be clearly marked out by the client’s representative
After removal of defective concrete, ensure that the reinforcing bars are free of frost, rust, dirt, grease, oil, curing compound, paints, impregnations or any other foreign matter likely to affect the bond or performance of the repair material
Where reinforcing bars have to be replaced, they must be secured to meet the client’s requirements.
 
PRIMING:
The concrete needs to be pre-soaked with clean potable water, leaving the concrete saturated but free of standing water.
 
MIXING:
Mix Pro-Struct 528VO-MCI with clean potable water using a mechanical mortar type mixer. Do not exceed recommended amount of mixing water stated on the package or technical data sheet.
 
APPLICATION:
Work the product into the concrete surface. Apply with a trowel, taking care not to leave air pockets. Apply from bottom of the cavity from one side to the other. When embedding reinforcement, ensure a minimum of 10mm above the reinforcing bar. Should multiple layers be required, roughen and pre-soak surface between layers.
 
DELAMINATING PLASTER:
Plaster of which the adhesion is suspect, must be removed down to sound brickwork, and re-plastered. Mortar that is soft and friable must be scraped out between the bricks and re-applied with a 1:3 cement/sand mortar. Coating Worx has allow for up to 10m² any additional plaster work will be charge on an ad hoc basis once brought to the attention of the trustees.
PRICE: TBA
CLOSE